Mitsubishi DSM/Evo Injector Set: 4 x 1150cc Peak & Hold / Low Impedance Ball & Seat Injectors. Great for E85 applications! Plug and play fitment without adaptors!
Fuel Injector Clinic injector sets are precisely flow matched to within 1%. Each injector within each set is individually numbered and results for each injector are listed on a detailed flow sheet included with the set. Dynamic flow matching is used only on injector sets where the additional time and cost are justified by the corresponding benefits gained during the tuning process.
Fuel Injector Clinic injectors are flow tested and rated at 43.5psi (3Bar) at 75ºF average fuel temperature using CF-16B calibration fluid.
The superior spray pattern and atomization make these injectors easy to tune and provide great drivability.
Fuel Injector Clinic injectors are set up to and include all o-rings needed to fit the factory application for the listed vehicle. For aftermarket or other unusual setups please contact us prior to placing your order to make sure you receive injectors that fit properly.
Every injector is covered against failure caused by defects in original manufacture by our 12 month warranty.
Fuel Injector Clinic injectors use the factory electrical connector or include solder-in pigtails. You can purchase adaptor ‘plug-n-play’ harnesses to avoid cutting your stock harness as an optional extra.
This injector set contains low impedance injectors matched to your vehicle’s factory fuel injector control system which may include an injector resistor pack working in conjunction with your vehicle’s OEM ECU. These injectors are also suitable for use with an aftermarket ECU made or set up for low impedance injectors driven by a peak and hold signal or by a saturated signal together with a resistor pack.
Injector Specs:
Cylinder Quantity: 4
Impedance: Low-Z
WHP Supported at 43.5 psi 0.9DC Turbo BSFC 0.6: 559
WHP Supported at 58 psi 0.9DC Turbo BSFC 0.7: 645
